Amantii WM-50 Instrucciones de operaciones Pagina 1

INSTALLATION ANDOPERATING INSTRUCTIONS FORWALL- MOUNT AND BUILT- IN UNITS09 13-01WM-BI-26-3623 WM-BI-26-3623-WHTGLSWM-BI-34-4423 WM-BI-34-4423-WHT

50” 24“ or 127 cm 60 cm94.6lbs or 43kgNOTE: This appliance must be electricallywired and grounded in accordance withlocal codes. In the absence

73” 24“ or 185.5 cm 60 cm126.5lbs or 57.5kgNOTE: This appliance must be electricallywired and grounded in accordance withlocal codes. In the ab

12WM-BI-2428-VLR20 ” 26“ or 50.8 cm 66 cm57.2 lbs or 26kg24” or 61cmNOTE: This appliance must be electricallywired and grounded in accordanc

iINSTALLATION OVERVIEWNOTE: BEFORE YOU INSTALLSITE SELECTIONwall.Review and consider all of the following condi-r r wo (2) wallethods:t-In (page 17)W

14PACKAGE CONTENTSAEBCDPart1ssalGAB 1C Wall Bracket 1D 1EDecorative Media1CONTENTSPartDescription QuantityPictureScrew0.16 in. x 1.0 in.Wall Plug 0.3

15PACKAGE CONTENTSAEBCDPart1AB1C 1D1EDecorative Media1CONTENTSPartDescription QuantityPictureScrew0.16 in. x 1.0 in.Wall Plug 0.3 in. x 1.5 in. 2020BA

16PACKAGE CONTENTSAEBCDPart1AB1C 1D1EFire Glass Media1CONTENTSPartDescription QuantityPictureScrew0.16 in. x 1.0 in.Wall Plug 0.3 in. x 1.5 in. 1010BA

NEW CONSTRUCTION OR RENOVATIONCAUTION:Two people may be needed tomoisture and is located at least 0.91 m or -als such as curtains or drapes, furniture

-FIREPLACE INSTALLATION BUILT INjust the unit to achieve the desired amountof depth. k r oww-and the wall studs. NOTE BEFORE YOU INSTALLWall18214&qu

-BI-50-FLUSHMT INSTALLATIONjust the unit to achieve the desired amountof depth. k r oww-and the wall studs. NOTE BEFORE YOU INSTALLWall1912" [1

-BI-50/72-DEEP INSTALLATION- BUILT INjust the unit to achieve the desired amountof depth. k r oww-and the wall studs. 20WDHW(") D(") H(&quo

-WM-BI-2428-VLR INSTALLATIONjust the unit to achieve the desired amountof depth. k r oww-and the wall studs. 21WDHW(") D(") H(")WM-BI-

the bottom of unit.4. Drive mounting screws into the mounting bracket onFloorIt is strongly recommended that the screws be screwed into the wall studs

Media oponsModels WB-BI-26-3623, WM-BI-34-4423, WM-BI-48-5823, WM-BI-72-8123, BI-50-FLUSHMT-BLKGLS are shipped with an LED ember log that is pre-inst

Fire Glass Media - Log Installaon1. Removing the logUnplug the unit from wall and make sure controls are switched off. The LED log is shipped in place

ear saNOTE: BEFORE YOU INSTALLFRONT INSTALLATIONIt is recommended that two people install the front onto the appliance, w fety glasses and gloves when

26Fix plate3. Put the plate back and screw back.appliance directly to the house hold wiring.electrician may remove the cord connection, and wire the

and ember will be on. The heater will be off. Press again, the fireplace will turn off.The button located at the top position of the remote control is

and ember will be on. The heater will be off. Press again, the fireplace will turn off.The button located at the top position of the remote control

REMOTE CONTROL OPERATION 1. For remote to function make sure the heater is plugged-in and mains power switch located on the bottom right hand side is

3TABLE OF CONTENTS CONGRATULATIONS! In selecting this Amantii Wall Mount OR Built-in electric fireplace, you have chosen the finest and most dependabl

30 1. Power ON/OFF switch 2. Heat control button 3. Flame control button 4. HEATER LED 5. POWER LED Plug the heater into a suitable outle

31REPLACING THE REMOTE CONTROL BATTERYWhen the remote control stops operating or its range seems reduced, it is time to replace the batteries with new

32CARE AND MAINTENANCE CLEARANCE TO COMBUSTIBLESKeep electrical cords, drapery, furniture and other combustibles at least 3 ft. from the front of the

33FIREPLACE MAINTENANCEDisconnect power before performing any maintenance or cleaning to reduce the risk ofWARNING:LED LIGHT BULB REPLACEMENTLED light

Replace AA batteries in remote control. If problem persists,a. Appliance is not plugged inTROUBLE SHOOTINGSYMPTOMPOSSIBLE CAUSES CORRECTIVE ACTIONFire

SERVICE HISTORYNOTES:This heater must be serviced annually depending on usage.Date Dealer Nameservice technicianNameservice Performed special Concerns

Defects must be brought to the aenon of Amani Technical Service by contacng Amani at (1-888-406-8764), or at 1503-7088This limited warranty doe

ELECTRIC FIREPLACES

IMPORTANT INSTRUCTIONSWARNING!SAVE THESE INSTRUCTIONS4BAC DFig. 1Grounding PinCover Of Grounded Outlet BoxMetalScrewsAdapterGroundingMeansGroundingPin

27” 22” or 68.60 cm 55.9 cm55.68 lbs or 25.31kg1500W19W6 3/4” or 17.30 cm35 1/2” or 90.20 cm23” or 58.40 cm25W sideLeftt Appliance Width 750

35” 22“ or 88.9 cm 55.9 cm65.78 lbs or 29.90kg43 1/2” or 110.50 cmWM-BI-34-4423NOTE: This appliance must be electricallywired and grounded in

49” 22“ or 124.46 cm 55.9 cm 82.17 lbs or 37.35kg57 1/2” or 146 cmWM-BI-48-5823NOTE: This appliance must be electricallywired and grounded in

72 1/2” 22“ or 184 cm 55.9 cm NOTE: This appliance must be electricallywired and grounded in accordance withlocal codes. In the absence ofloc

49” 22“ or 124.46 cm 55.9 cm80lbs or 36.35kg51” or 129.6 cmNOTE: This appliance must be electricallywired and grounded in accordance withlocal